Table of Contents
Advertisement
Pin assignment of USB 2.0 connector
The USB interface is intended for connecting peripheral devices (USB 2.0). The connector is without function
in the current firmware version, but is optional for future planned applications.
Pin number
SIGNAL NAME
1
VDC
2
D -
3
D+
4
GND
Pin assignment of Smartcard Reader (ISO 7816 Standard)
The integrated SIM card reader is intended for saving and restoring the configuration data.
Pin number
SIGNAL NAME
1
VCC 5 Volt
2
RESET
3
CLOCK
4
n/c
5
GND
6
n/c
7
I/O
8
n/c
7. Initial start-up / Getting Started
Configuration of the Router by using an Internet browser
Note
The configuration of the device can be done either via LAN or WAN RJ45 ports.
Connect the unit to a 24V DC (3-pin plug) power source. The corresponding plug is included.
During the initial boot phase, the PWR LED is flashing. The Router is ready when the PWR LED is lit
constantly (after about 30 seconds).
Connect the Router to the Ethernet interface of a configuration PC using a RJ45 network cable.
It is possible to use a standard Ethernet patch cable or a crossed network cable. By default both Ethernet
ports are configured with autonegotiation.
Copyright © 2013 Weidmüller Interface GmbH & Co. KG
All rights reserved. Reproduction without permission is prohibited.
14 / 103
Hide quick links:
Advertisement
Table of Contents
