Table of Contents
Advertisement
Switch is set to ON is not properly connected.
If neither of these two conditions occurs, the Fault circuit will be closed.
DIP Switch Settings
ON
DIP
1
2
3
4 5 6 7
8
9
ON: Enables the corresponding PORT Alarm. If the port's link fails, the relay
will form an open circuit and the fault LED will light up.
Off: Disables the corresponding PORT Alarm. The relay will fo
circuit and the Fault LED will never light up.
LED Indicators
The front panel of the Ethernet Switch contains several LED indicator
function of each LED is de
scribed in the table below.
LED
Color
State
On
AMBER
PWR
1
Off
On
AMBER
PWR2
Off
On
RED
FAULT
Off
On
GREEN
Blinking Data is being transmitted at 10 Mbps
10M
Off
On
100M
GREEN
Blinking Data is being transmitted at 100 Mbps
(TP)
Off
On
100M
GREEN
Blinking Data is being transmitted at 100 Mbps
(FX)
Off
Auto MDI/MDI-X Connection
The Auto MDI/MDI-X function allows users to connect the 10/100BaseTX
ports of the Ethernet Switch to any kind of Ethernet device, without needing to
rm a closed
Description
Power is being supplied to power input
PWR1
Power is not being supplied to power input
PWR1
Power is being supplied to power input
PWR2
Power is not being supplied to power input
PWR2
When the corresponding PORT alarm is
enabled, and the port's link is inactive.
When the corresponding PORT alarm is
enabled and the port's link is active, or
when the corresponding PORT alarm is
disabled.
TP port's 10 Mbps link is active
TP Port's 10 Mbps link is inactive
TP port's 100 Mbps link is active
100BaseTX Port's link is inactive
FX port's 100 Mbps is active
100BaseFX port is inactive
- 10 -
s. The
Advertisement
Table of Contents
