4. Set the basic IP configuration and activate NAT masquerading
► Select menu Configuration IP configuration
Figure A2-2: Default factory settings of menu IP configuration
► Configure the menu entries as below described
Operational mode:
IP address parameters WAN Port:
IP address parameters LAN Port:
Default gateway
► Click button "Apply settings" to activate the new settings.
Now the configured parameters will be activated (but not saved). After a few seconds the web interface displays the
new IP addresses as shown in Figure A2-3.
Copyright © 2013 Weidmüller Interface GmbH & Co. KG
All rights reserved. Reproduction without permission is prohibited.
Screenshot of the default IP
configuration of the Router
IP Router
static
192.168.20.254
255.255.255.0 (Class C)
Click and Set the checkbox NAT (masquerading)
static
192.168.10.254
255.255.255.0 (Class C)
NAT (masquerading) not set (leave checkbox empty)
Can be left blank because there exists no further target network
55 / 103