Table of Contents
Advertisement
Image 5-28
Level out the first tiles.
Image 5-29
Fasten tiles and frame after levelling.
5.6.4
Installation of the third and following precision frames
Necessary tools
•
19 mm open ended spanner.
•
Ratchet handle with short extension bar and 10 mm hexagon socket.
Necessary parts
•
Precision frames.
•
Two half size precision frames.
•
Solaris LD tiles.
•
Tile fixation nuts (K).
•
Bag with M12x30 hexagon head bolts (A).
•
Bag with M12 plain washers (B).
•
Bag with M12 spring lock washers (C).
How to install the third and following precision frames ?
1. Attach the next precision frame loosely next to the previous one using four M12x30 hexagon head bolts (A), containing a M12
plain washer (B) and a spring lock washer (C). Do not fasten yet. Use the outer mounting holes of the precision frame.
Tip:
Let the height adjustment bracket of the precision frame rest upon the lower horizontal profile of the support structure.
Adjust the height of the precision frame by turning the bolt in or out the height adjustment bracket until the mounting holes
on the frame correspond with the mounting holes on the support structure.
2. Attach the top and bottom tile loosely between the last and previous precision frame using four tile fixation nuts per tile. Do not
fasten yet.
Note: The final approach of the tile into the precision frame must be at right angle.
The tile fixation nuts are fixed to the tile on delivery. So, you have to remove the nuts before inserting the tile into the
precision frame.
3. Adjust the height of the last installed precision frame until the vertical seam between the previous and last installed tile is equally
parallel over the hole tile. Lower down the precision frame in case the seam is at the bottom bigger than at the top of the tile and
vice versa. Try to get the best result for the top and bottom tile. (image 5-30)
R5976773 SOLARIS LD DISPLAY 02/12/2004
5. Installation procedures
39
Advertisement
Table of Contents
