Barco Solaris LD 120-8 Installation & Service Manual page 25

6. In this stage the finishing touch can be applied to the Solaris LD display. This is done by framing the extremities of the display
by closing up the sides and the rear of the display using cladding parts. Cladding must be placed following next sequence:
a) "Installation of the top- , bottom- and side-cladding support brackets", page 49.
b) "Installation of the top and bottom cladding", page 50.
c) "Installation of the left and right side cladding", page 53.
d) "Installation of the rear cladding", page 54.
7. The second last stage in the process is the installation of the Solaris LD software on the local PC. Refer to the "User guide" of
the Solaris LD software for installation instructions.
8. Finally the Solaris LD system is ready to start up. After energizing the Solaris LD display and the Solaris D2 digitizer, the system
can be controlled and content scheduled with the Solaris LD software. Refer to the "User guide" of the Solaris LD software
for more information on how to schedule content for the Solaris LD display.
R5976773 SOLARIS LD DISPLAY 02/12/2004
4. Set up process of a Solaris LD display
21