Table of Contents
Advertisement
Necessary tools
•
Small flat blade screwdriver.
•
Ratchet handle with short extension bar and 10 mm hexagon socket.
How to align the Solaris LD tiles in the Z-direction ?
1. Release the tile fixation nut of the most inner corner of the tile. Use a ratchet handle with short extension bar and 10 mm hexagon
socket. (image 5-42)
Note: It's not necessary to remove the tile fixation nut, just loosen.
2. Turn the tile fixation bolt, with released fixation nut, counterclockwise until the front of the tile is aligned with the front of the
neighboring tiles. Use a small blade screwdriver. (image 5-43)
Warning: The maximum allowed adjustment range is 1 millimeter which correspond with a 360° turn counterclockwise of the
tile fixation bolt. Turn the tile fixation bolt as far as possible clockwise to know the start position of the 360° turn.
3. Fasten the tile fixation nut. (image 5-44)
Image 5-42
Release the tile fixation nut.
360° max
Image 5-43
Adjust the tile fixation bolt until the tile is aligned.
R5976773 SOLARIS LD DISPLAY 02/12/2004
1 mm max
5. Installation procedures
47
Advertisement
Table of Contents
