Table of Contents
Advertisement
2. INSTALLING STANDARD AND OPTIONAL COMPONENTS
3.
Connect the display signal cable and keyboard
cable to the processor unit circuit boards as
indicated in Figure 2-14, and tighten the
thumbscrews until they are finger tight. (All
cables are labeled on thei r respective plugs.)
CAUTION
Do not connect the power cord at this time.
FLOPPY
DRIVE---;.;.-;... .... ..;. .. ,
BUS
EXTENOER-';';"'~"
AS-232-C
PORTS
IDTE
• .;..;.....;..-...;.;..--PR INTE R
/DCE
Figure
2-14.
Connector Locations
on
Processor
4.
If applicable, connect the Ethernet drop cable
to the processor unit circuit board as indicated.
Lock the cable into place by pressing the silver
slide-lock down.
5.
Record the presence of an Ethernet connection
on the Hardware Checklist in Appendix A,
Hardware Configuration.
6.
Use the screwdriver that is supplied with the
processor to tighten the display cable, and the
keyboard cable.
' . ,
,-.
~.,
XEROX 1186 HARDWARE IN5TALLAf ION.
L.
Y KIL r(t:L.tA:lt.
i:.1
Advertisement
Table of Contents
