Running New System Checkout From The Network - Xerox 1186 Hardware Installation

4. NEW SYSTEM CHECKOUT
Running New System Checkout
from the Network
1. Press the B Reset button on the processor front
panel. Boot icons, which represent the function
keys at the top of your keyboard, appear at the
bottom of your screen.
2. Press the F7 key within 30 seconds after the
boot icons appear. This initiates a special
diagnostic boot from the network and
automatically starts the system checkout.
While these diagnostics are running, various
maintenance codes will be displayed at the top
center of the screen. In addition, various
patterns will appear on the screen at different
times. During the test, there will be extended
perionds of time (up to three minutes on large
memory systems) during which there is no
change in the state of the display. This is
perfectly normal and is no cause for concern.
3. If the test completes successfully (the boot icons
will appear on the screen), proceed to
II
Runni ng
Rigid Disk Confidence Test from the Network ",
below.
4. If an error is detected, the system alternately
displays two sets of 4-digit alphanumeric
characters at the top center of the screen. Each
set of characters is displayed for approximately
one second.
5. Type R. The system displays a single 4-digit
number representing a maintenance action
code. Call Customer Support and provide them
with this information. Customer Support will
provide you with further instructions.
XEROX 1186 HARDWARE INSTALLATION, LYRIC RELEASE
55