Cid 0105 Fmi 03 Intake Manifold Temperature Sensor Open Circuit Or Shorted High; Cid 0105 Fmi 04 Intake Manifold Temperature Sensor Shorted Low; Cid 0110 Fmi 03 Engine Coolant Temperature Sensor Open Circuit Or Shorted High - Perkins 1104E Series Troubleshooting Manual

RENR2696-01
System Response:
The ECM will log the diagnostic code. The diagnostic
code may be viewed on the electronic service tool.
The ECM will flag the intake manifold pressure as
invalid data. The intake manifold pressure is set to
a default value.
Perform the following diagnostic procedure: "Engine
Pressure Sensor Open or Short Circuit - Test"
Results:
•
OK – STOP.
CID 0105 FMI 03 Intake
Manifold Temperature Sensor
Open Circuit Or Shorted High
Conditions Which Generate This Code:
The Electronic Control Module (ECM) detects all of
the following conditions:
•
The ECM reads signal voltage that is above
normal.
•
The ECM has been powered for at least fifteen
seconds.
System Response:
The ECM will log the diagnostic code. The diagnostic
code may be viewed on the electronic service tool.
The ECM flags the intake air temperature as invalid
data and a default value is used.
Possible Performance Effect:
•
Low power
• Poor cold starting
Troubleshooting:
Perform the following diagnostic procedure: "Engine
Temperature Sensor Open or Short Circuit - Test"
Results:
•
OK – STOP.
CID 0105 FMI 04 Intake
Manifold Temperature Sensor
Shorted Low
Conditions Which Generate This Code:
The Electronic Control Module (ECM) detects all of
the following conditions:
• The ECM reads signal voltage that is below normal.
•
The ECM has been powered for at least fifteen
i01798150
seconds.
System Response:
The ECM will log the diagnostic code. The diagnostic
code may be viewed on the electronic service tool.
The ECM flags the intake air temperature as invalid
data and a default value is used.
Possible Performance Effect:
•
Low power
•
Poor cold starting
Troubleshooting:
Perform the following diagnostic procedure: "Engine
Temperature Sensor Open or Short Circuit - Test"
Results:
•
OK – STOP.
CID 0110 FMI 03 Engine
Coolant Temperature Sensor
Open Circuit Or Shorted High
Conditions Which Generate This Code:
The Electronic Control Module (ECM) detects all of
the following conditions:
•
The ECM reads signal voltage that is above
normal.
•
The ECM has been powered for at least three
seconds.
69
Troubleshooting Section
i01798151
i01798152