Perkins 1104E Series Troubleshooting Manual page 17

RENR2696-01
Table 8
Orange Red lamp
lamp (status)
(status)
OFF OFF
OFF ON
Flashing OFF
OFF Flashing
ON OFF
ON ON
ON Flashing
Flashing ON
Use the lamps to identify active
diagnostic codes.
The indicator lamps can be used to identify an active
code by flashing in a sequence that will identify the
active code. The active code that is flashed by the
indicator lamps is only the component identifier (CID).
The indicator lamps cannot identify the fault with the
component. The active code that is flashed by the
indicator lamps is not a Failure Mode Identifier (FMI).
Comments
No faults were detected.
The oil pressure is low.
Either the coolant temperature
is high or the intake air
temperature is high. The
engine may be derated.
Either a fault has caused the
engine to be automatically
shut down or the engine has
exceeded the condition for a
derate.
An electrical fault has been
detected.
The oil pressure is low and
there is an electrical fault.
Either a fault has caused the
engine to shut down or the
engine has exceeded the
conditions for a derate. There
is also an electrical fault.
The oil pressure is low and
either the coolant temperature
or the intake air temperature
is high. The engine may be
derated.
Table 9
CID Description
number
0041 8 Volt Power Supply
0091 Throttle Position Sensor
0100 Engine Oil Pressure Sensor
0102 Intake Manifold Pressure
Sensor
0105 Intake Manifold Air Temperature
Sensor
0110 Engine Coolant Temperature
Sensor
0174 Fuel Temperature Sensor
0247 J1939 Data Link
0253 Personality Module
0262 5 Volt Power Supply
0320 Engine Speed/Timing Sensor
0342 Secondary Engine Speed
Sensor
0774 Secondary Throttle Position
Sensor
1684 Fuel Injection Pump
1743 Mode Selector Switch for
Engine Operation
1894 Cruise Control Status Switch
1895 Toggle Switch for Cruise
Control Speed
When the Flash Code feature is activated the
indicator lamps will flash the codes of all active
codes. Activation of the indicator lamps is achieved
by cycling the keyswitch OFF and ON twice within
3 seconds.
There will be a delay of 2 seconds before the lamps
start to flash the identity of any active code.
An active CID with two digits will be flashed in
the following sequence. There will be a number of
flashes. The number of flashes will equal the first
digit. There will be a delay before a second number
of flashes. The second number of flashes will equal
the second digit. For example, a CID code of 41 will
be four flashes, a delay and the one flash. A three
digit CID code will have two delays between the
sequence of flashes. A four digit CID code will have
three delays between the sequence of flashes.
Each flash of the lamp will be 0.5 seconds long.
There will be a delay between each flash of 0.3
seconds.
17
Troubleshooting Section
Flash
code
517
154
157
135
133
168
165
514
416
516
141
142
155
158
144
427
428