168
Troubleshooting Section
Verify that the repair has eliminated the faults.
STOP.
•
Not OK – The sensor resistance is out of the
nominal range.
Repair: Perform the following procedure in order
to check and install the new sensor:
1. Before installing the new sensor, measure the
resistance of the new sensor.
If the new sensor resistance is in the correct
range, install the new sensor in the engine.
Ensure that the O ring is installed and free of
damage.
Seat the sensor and tighten the setscrew.
If the sensor will not seat, repair the sensor or
replace the sensor, as required.
Ensure that the sensor is properly oriented
and that the harness is secured in the proper
location.
2. Verify that the repair eliminates the problem.
STOP.
RENR2696-01