Perkins 1104E Series Troubleshooting Manual page 33

RENR2696-01
Flash Programming a Personality
Module
1. Connect the electronic service tool to the service
tool connector.
2. Select "WinFlash" from the "Utilities" menu on the
electronic service tool.
"WinFlash" will try to detect an ECM.
3. When an ECM has been detected, the "ECM
Selector" window will appear. Select the
appropriate ECM that needs to be flashed and
press "Browse".
The "Flash File Selection" window will appear.
4. The flash files are located on a disk drive and in
a directory. Select the correct disk drive and the
correct directory from "Drives" and "Directories" on
the electronic service tool.
A list of flash files will appear.
5. Select the correct file from the list of flash files.
Read the "File Info" and the "Description" in order
to verify that the correct file is selected. Select
"OK".
6. Select the "Begin Flash" button in order to program
the personality module.
When the flash is completed, this message will
appear: "Flash Completed Successfully".
7. Start the engine and check for proper operation.
a. If a diagnostic code of 253-02 Incorrect
ECM Software is generated, program any
parameters that were not in the old personality
module.
b. Access the "Configuration" screen under
the "Service" menu in order to determine
the parameters that require programming.
Look under the "Tattletale" column. All of the
parameters should have a tattletale of 1 or
more. If a parameter has a tattletale of 0,
program that parameter.
"WinFlash" Error Messages
If you receive any error messages during flash
programming, click on the "Cancel" button in order
to stop the process. Access the information about
the "ECM Summary" under the "Information" menu.
Make sure that you are flashing the correct file for
your engine.
33
Troubleshooting Section