Indicator Lamps - Perkins 1104E Series Troubleshooting Manual

RENR2696-01
(Table 3, contd)
1684 02
1684 03
1684 04
1684 05
1684 07
1684 08
1684 09
1684 10
1684 11
1684 12
1684 14
1690 08
1743 02
1894 02
1895 02
Event Code
E015
E016
E017
E025
E027
E039
E040
E054
E056
E100
E190
E442
E883

Indicator Lamps

Some engine applications are equipped with Indicator
Lamps. Indicator lamps can be used as a diagnostic
aid. There are two lamps. One lamp has an orange
lens and the other lamp has a red lens.
These indicator lamps can be used in two ways:
J1077 02 Fuel Injection Pump, software failure
J1077 03
Fuel Injection Pump, fuelling fault
J1077 04 Fuel Injection Pump, supply voltage fault
J1077 05 Fuel Injection Pump, invalid pulse width
J1077 07 Fuel Injection Pump, mechanical fault
J1077 08
Fuel Injection Pump, crankshaft reference fault
J1077 09 Fuel Injection Pump, CAN fault
J1077 10
Fuel Injection Pump, fuel shutoff signal error
J1077 11 Fuel Injection Pump, internal sensor fault
J1077 12 Fuel Injection Pump, device failure
J1077 14 Fuel Injection Pump, no communications
Analogue Speed Control, signal abnormal
Engine Mode Selection Switch State, invalid state
Set Speed Control Disengage Switch, invalid state
Set Speed Control Speed Toggle Switch, invalid state
CID FMI Code
110 16 High Engine Coolant Temperature Derate
110 00 High Engine Coolant Temperature Sutdown
110 15 High Engine Coolant Temperature Warning
105 16 High Intake Air Temperature Derate
105 15 High Intake Air Temperature Warning
100 18 Low Engine Oil Pressure Derate
100 01 Low Engine Oil Pressure Shutdown
174 16 High Fuel Temperature Derate
174 15 High Fuel Temperature Warning
100 17 Low Engine Oil Pressure Warning
190 15 Engine Overspeed Warning
Engine Failed To Stop With A No-Fuel Command
Engine Failed To Stop When Fuel Solenoid Disengaged
i01878735
•
The indicator lamps can be used to identify the
current operational status of the engine. The
indicator lamps can also be used to indicate that
the engine has a fault. This system is automatically
operated via the ignition switch.
•
The indicator lamps can be used to identify active
diagnostic codes. This system is activated by
pressing the Flash Code button.
15
Troubleshooting Section