Coolant Temperature Sensor - Remove And Install - Perkins 1106C Series Disassembly And Assembly

KENR6932
Illustration 337
Typical example
1. Lubricate a new O-ring seal (5) with clean engine
oil. Install the new O-ring seal into the first groove
in position sensor (3).
2. Remove the plug from the hole in the fuel injection
pump for the position sensor.
3. Align the hole in position sensor (3) with the hole
in the fuel injection pump. Install the position
sensor to the fuel injection pump.
Note: Do not use bolt (4) to pull the position sensor
into position against the fuel injection pump.
4. Install bolt (4). Tighten the bolt to a torque of
22 N·m (16 lb ft).
5. Connect harness assembly (2) to position sensor
(3).
6. Slide locking tab (1) into the locked position.
Coolant Temperature Sensor -
Remove and Install
Removal Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, test-
ing, adjusting, and repair of the product. Be prepared
to collect the fluid with suitable containers before
opening any compartment or disassembling any com-
ponent containing fluids.
Dispose of all fluids according to local regulations and
mandates.
1. Drain the coolant from the cooling system, to a
level below the coolant temperature sensor, into
a suitable container for storage or for disposal.
Refer to Operation and Maintenance Manual,
"Cooling System Coolant - Change" for the correct
draining procedure.
g01341704
Illustration 338
2. Slide locking tab (1) into the unlocked position.
3. Disconnect harness assembly (2) from coolant
temperature sensor (3).
4. Use a deep socket in order to remove coolant
i02654460
temperature sensor (3) from the cylinder head.
5. Remove O-ring seal (4) from the coolant
temperature sensor (3).
Installation Procedure
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Disassembly and Assembly Section
NOTICE
NOTICE
167
g01341684