Changing Front Axle Oil - Zetor UTILIX HT Series Operator's Manual

Changing front axle oil

1. Remove the drain plug from the center of the differential and drain the oil. Do the same for all other
front axle drives.
2. Return and tighten all drain plugs.
3. Remove the top plug (bleed plug) from each rear wheel drive to bleed it.
4. Remove the dipstick from the filler hole, pour 10 liters of oil and wait until it flows into the rear wheel
drives.
5. Check the oil level using the dipstick, return the bleed plugs on both rear wheel drives and tighten
them.
1 - Maximum Level
2 - Minimum Level
1 - Level gauge & oil filler
2 - Front axle oil drain plug
Important:
After refilling the prescribed amount of new oil, the level measured by the dipstick may be higher
than permitted - due to incomplete filling of the front-wheel axle drive mechanism - this discrepancy
will disappear after being put back into operation. Unscrew the bleed plugs to accelerate the proper
pumping of the oil by the front axle drive system.
100
MAINTENANCE INSTRUCTIONS
U18N078
U18N079