Connecting And Disconnecting Implement - Zetor UTILIX HT Series Operator's Manual

Connecting and disconnecting implement

If the PTO is used, remove the cover (1) from the PTO
shaft.
Connect the lower left link, then connect the lower right
link using the adjusting handle, if necessary.
Connect the upper link.
Connect the PTO shaft to the tractor and make sure it is
properly locked in place.
Adjust the stabilizer bars so that it corresponds to the
implement and tighten the retaining nuts.
To disconnect the implement, proceed in the reverse
order.
Caution: Do not attach a PTO shaft while the engine is running and ensure all safety shields
are in place.
Caution: Be especially careful when working with an aggregated implement near other people
or vehicles. Take into account the overall width of the unit to prevent traffic accidents.
CONTROLS, INSTRUMENTS & OPERATIONS
U18N048
51