Front Axle Oil Check And Change - Zetor PRIMO HT 20 NC Operator's Manual

Front Axle Oil Check and Change

1- Front-Wheel Axle Oil Filler
2 - Front Axle Oil Drain Plug
1- Upper Mark
2- Lower Mark
3- Level Dipstick
(1) Check
1. Pull out the dipstick, wipe and reinsert. Then pull it out and check that the oil level is between the
upper and lower mark.
2. In case of insufficient amount of oil, refill.
3. There is one drain hole on each side of the front axle.
(2) Change
1. To drain the engine oil, unscrew the drain plugs at the bottom of the axle and the left / right final
drives. As hot fluid comes from the engine first, be careful not to burn yourself.
2. After draining the oil, screw the drain plug back on.
3. Fill the specified amount of the specified oil through the filler hole.
NOTE
The amount of front axle oil added must not exceed the upper limit.

Check the front axle oil before starting the engine or at least 5 minutes after stopping it.

If you want to use a different oil from a different manufacturer or oil with a different viscosity,

drain the used oil completely before filling.
Notice:
If oil comes in contact with the skin, it can irritate it and cause skin disease. In this case, wash

your skin with soap and water or hand cleaner.
Before draining the oil, make sure that the engine has cooled down sufficiently. When

changing the oil immediately after stopping the engine, the engine is very hot and can cause
burns.
100
MAINTENANCE
PRIMOHT20NC_0098
PRIMOHT20NC_0099