Zetor UTILIX HT Series Operator's Manual page 50

The PTO does shall not rotate when one of the two switches is in the OFF position
The following table explains how the PTO operates in two different positions (Manual & Auto) of the PTO
control switch with the PTO ON / OFF switch in the ON position.
PTO PTO
ON/OFF Control Hydraulic Position
Control Lever.
Switch Switch
Manual
On Either raised or lowered Glows
Mode
Auto
On Either raised or lowered Blinks
Mode
Auto
On Raised
Mode
Auto
On Lowered
Mode
The table above provides information on PTO safety functions. If the indicator light on the instrument
panel flashes, this indicates to the operator that the PTO is in the ON position but is not currently
rotating temporarily because the implement is lifted.
The PTO starts to rotate immediately when the implement is lowered.
The operator must observe the warning signal in order to ensure that there are no other persons or
bystanders in the area around the tractor, as rotating parts of some implements may accidentally
cause injury to persons near the tractor.
Stopping the PTO when lifting the implement while controlling position shall prevent damage to the
implement or PTO.
CONTROLS, INSTRUMENTS & OPERATIONS
PTO Monitor
Lamp on the dash panel
Blinks
Glows
PTO SHAFT
Rotates
Stationary
Stationary
Rotates
49