Tachometer; Hour Meter; Fuel Gauge And Water Temperature Gauge; Hazard Warning Signal Switch - Zetor UTILIX HT Series Operator's Manual

Tachometer

This meter shows the revolutions of the engine and the
PTO shafts as well as the travel speed in top gear.

Hour meter

The operating hour meter consists of digits where the last
digit indicates 1/10 of an hour. It shows the number of
operating hours of the tractor.
The indicator light at the bottom of the operating hour
meter should flash during operation to indicate that the
system is operating properly.

Fuel gauge and water temperature gauge

Fuel gauge
Shows the amount of fuel in the tank when the ignition
switch is ON.
Water temperature gauge
Shows the water temperature with the ignition switch ON.
C is low to normal temperature.
H is high temperature.
If the pointer is in the red H segment the engine is
overheating.
Refer this book to rectify the problem.

Hazard warning signal switch

Push the hazard warning signal once to operate the
hazard warning light. (Left and right turn indicators flash).
Push the hazard warning light switch again to switch off
the hazard warning lights.
1 - Hazard warning signal S/W
46
CONTROLS, INSTRUMENTS & OPERATIONS
U18N014
UCL18N013
U18N015
UCL18N015