How To Use Of Jacks - Zetor UTILIX HT Series Operator's Manual

How to use of jacks

Front axle
Rear axle
- If the tractor must be lifted for servicing, take it to a suitably equipped workshop.
- Carry out the following operations before any operation about the tractor. Engage the four-wheel drive, the
first gear and the parking brake and put chocks to the wheels touching the ground.
- Before lifting the tractor, avoid its swinging by means of wooden wedges applied to the front axle
- Use jack lifts of suitable capacity and apply them at the centre of the front and rear axles and paying due
attention to weight distribution.
- No decals for the lifting point are applied on the tractor, as they would be, too difficult to apply in the
available spaces and would be all too easlly removed or effaced during normal operation of the tractor.
Note: Apply the jack lift to the lifting points according to the type of operation and following the
safety procedures given before.
MAINTENANCE INSTRUCTIONS
U18N114
U18N115
115