EMC Connectrix B Series Hardware Reference Manual page 99

!
Installing a power supply
!
CAUTION
Support the power supply unit from underneath while
removing it from the chassis.
3. Use the handle to pull the power supply out of the chassis.
4. If you are not replacing the removed power supply unit, orient
the filler panel so the handle is vertical and the side tabs are on
the right; then, push the filler panel into the slot.
CAUTION
Do not force the installation of the power supply unit or filler
panel. If the part does not install easily, ensure that it is properly
oriented.
Ensure that the handle is unlocked; otherwise, damage might occur
to the power supply unit and chassis during the installation.
To install a power supply:
1. If a filler panel covers the slot, pull it out by the handle (see
Figure 18).
2. Orient the power supply unit with the handle toward the front of
the chassis and the LEDs on the left.
3. Unlock the handle by pressing the locking tab.
4. Insert the unlocked power supply unit completely into the slot
and push the handle up until it clicks.
Verify that the power supply unit is seated by pulling gently on
the handle.
5. Verify that the power LED on the power supply unit displays a
steady green light (see
If it does not, ensure that both AC power connector cables are
plugged in and both AC power switches are flipped to 1 (AC
switch lights up green).
Remove and Replace System Components
Figure 9 on page 63).
Replacing a power supply and filler panel
99