EMC Connectrix B Series Hardware Reference Manual page 84

Remove and Replace System Components
Installing a filler panel
84
EMC Connectrix B Series ED-48000B Hardware Reference Manual
5. Verify that the power LED on the port blade is displaying a
steady green light (it might require a few seconds to turn on). If it
does not turn on, ensure that the port blade is firmly seated.
The LED patterns might temporarily change during POST and
other diagnostic tests.
6. Install SFP transceivers and cables in the port blade, as required.
7. Group and route the cables as desired (refer to
on page 39 for additional cabling instructions).
To install a filler panel with a handle:
1. Align the flat side of the filler panel inside the upper and lower
rail guides in the slot (see
filler panel into the slot (with slight pressure to the left) until it is
firmly seated.
2. Tighten the two captive screws using the Phillips screw driver.
To install a filler panel with ejector handles:
1. Orient the filler panel so that the ejectors are at the front of the
chassis and the flat side of the filler panel is on the left.
2. Open the ejectors to approximately 45 degrees, align the flat side
of the filler panel inside the upper and lower rail guides in the
slot, and slide the filler panel into the slot, with slight pressure to
the left, until it is firmly seated.
3. Close the ejectors by pushing the black handles toward the center
of the filler panel until the ejectors lock (slight audible click). The
levering action of the handles seats the filler panel in the slot.
To install a filler panel with pull tabs:
1. Orient the filler panel so that the captive screws are at the front of
the chassis and the flat side of the filler panel is on the left.
2. Tighten the captive screws in place, fastening the filler panel in
the chassis.
"Managing cables"
Figure 16 on page 80); then, slide the