EMC Connectrix B Series Hardware Reference Manual page 83

Installing a port blade
2. Lever both ejectors all the way open.
3. Pull the filler panel out of the chassis.
To remove a filler panel with pull tabs:
1. Unscrew the top and bottom captive screws on the filler panel.
2. Pull on the top and bottom pulling tabs to slide the filler panel out
of the chassis.
To install a port blade:
1. Orient the port blade so that the ports are at the front of the
chassis and the flat side of the port blade is on the left.
2. FC2-16, FC4-16, and FC4-32 port blades: Open the ejectors to
approximately 45 degrees, align the flat side of the port blade
inside the upper and lower rail guides in the slot (see
page 78), and slide the port blade into the slot, with slight
pressure to the left, until it is firmly seated.
PB-48K-48 port blade: Adjust the ejectors to the open position,
align the flat side of the port blade inside the upper and lower rail
guides in the slot, and slide the port blade into the slot, until it is
firmly seated (see
FC2-16, FC4-16, and FC4-32 port blades: Close the ejectors by
pushing the handles toward the center of the port blade until the
ejectors lock. The levering action of the handles seats the port
blade in the slot.
PB-48K-48 port blade: Adjust the ejectors to the closed position by
pulling them away from the center of the port blade.
3. FC2-16, FC4-16, FC4-32, and PB-48K-48 port blades: Tighten the
thumb screw inside each handle using the #2 Phillips screw
driver.
Note: The top thumb screw must be completely tightened for the
PB-48K-48 port blade to power on.
4. PB-48K-48 port blade: Skip to the next step.
FC2-16, FC4-16, and FC4-32 port blades: Turn the port blade on by
sliding the slider switch in the top ejector up, covering the thumb
screw.
Remove and Replace System Components
Figure 15 on page 79).
Replacing a port blade and filler panel
Figure 14 on
83