EMC Connectrix B Series Hardware Reference Manual page 134

Chassis Replacement
134
EMC Connectrix B Series ED-48000B Hardware Reference Manual
c. Repeat step a and step b for the remaining ports.
CAUTION
!
Do not route cables in front of the air exhaust vent (located
on the upper port side of the chassis).
The minimum bend radius for a 50-micron cable is 2 inches
under full tensile load and 1.2 inches with no tensile load.
Tie wraps are not recommended for optical cables because
they are easily overtightened.
d. Organize the cables as required. To use the cable management
pillars, insert the cables into the holes in the pillars, using a
separate hole for each cable. The cables can be routed to either
side of the management tray or down through the holes in the
tray.