EMC Connectrix B Series Hardware Reference Manual page 110

Remove and Replace System Components
Installing a WWN card
Please enter the word `continue' after the new WWN card has been installed:
continue
110
EMC Connectrix B Series ED-48000B Hardware Reference Manual
8. Set the WWN card on a static-free surface, such as a grounding
pad.
To install a new WWN card, follow these steps:
1. Unpack the new WWN card and save the packaging for returning
the faulty WWN card.
2. Install the WWN card as follows:
• To install a WWN card that has handles: Hold the card by the
handles and orient with the LEDs at the top (see
page 20); then, align the connector on the card with the
connector on the chassis (the connectors are keyed to ensure
correct installation) and use the "push pad" to press the card
onto the connector gently, until it is fully seated.
• To install a WWN card that does not have handles: Holding
the card by the edges, press the card onto the connector gently,
until it is fully seated. Using the Phillips screwdriver, secure
the WWN card to the chassis with the two attaching screws.
The WWN card retains slight freedom of movement after
installation.
CAUTION
!
Do not force the installation; if the card does not install easily,
ensure that it is correctly oriented.
3. Reinstall the WWN bezel:
a. Orient the bezel on the chassis (see
insert both retaining screws into the standoffs on the chassis
and tighten to finger-tight.
Note: If a serial console session is active, several "removal detected"
and "insertion detected" messages appear on the console as a result
of the replacement.
b. In the CLI session, type
replacement has been completed.
Figure 2 on page
to indicate that the
continue
Figure 2 on
20); then,