EMC Connectrix B Series Hardware Reference Manual page 75

Removing a cable management tray
Installing a cable management tray
To remove the cable management tray (shown on the right in
Figure 13 on page 74):
1. If the director is not operating: Remove the AC power connector
cables and continue with step 2, then remove the cable
management tray from the chassis.
If the director is operating: Remove any cables from the tray,
except the AC power connector cables.
2. Unscrew the two screws holding the tray to the chassis (see
Figure 13 for location of screws) and save them for reuse.
3. With the AC power connector cables still plugged in, detach the
cable management tray approximately 5 inches away from the
chassis.
4. Switch one AC power switch off (for example, part A in
Figure 13) and remove the corresponding AC power connector
cable (for example, remove the cable from part B in Figure 13)
from the chassis. Route the AC power connector cable through
the tray.
5. Plug the AC power connector cable back in to the connector on
the chassis, and switch the AC power switch on.
6. Repeat steps 4 and 5 for the other AC power switch and AC
power connector cable. The cable management tray is now
removed from the director chassis.
To install a lower mounting cable management tray (shown on the
right in Figure 13 on page
1. If the director is not operating: Remove any cables and orient tray
as shown in Figure
holes on the chassis. Then position and tighten the two screws.
The cable management tray is installed.
If the director is operating: Skip to step 2.
2. Switch one AC power switch off (for example, part A in
on page 74) and remove the corresponding AC power connector
cable (for example, remove the cable from part B in Figure 13)
from the chassis. Route the AC power connector cable through
the tray.
Remove and Replace System Components
74):
13, aligning the holes on the tray with the
Replacing the cable management tray
Figure 13
75