EMC Connectrix B Series Hardware Reference Manual page 36

Installation, Setup, and Login
36
EMC Connectrix B Series ED-48000B Hardware Reference Manual
1 AC Switch
2 AC Power Receptacle
3 Jack Screw
4 Clamping Screw
4. Loosen the clamping screw on each retainer, insert the power
cords through the retainers into the power receptacles on the
ED-48000B, and tighten the clamping screws. The power cords
are designed to bend to the left, so each should route to an
opposite side of the chassis.
5. Ensure that the power cord has a minimum service loop of 6
inches available at the connection to the switch and is routed so
that it is not exposed to stress.
6. Connect the power cords to the PDUs within the Connectrix
cabinet.
7. Flip both AC power switches to 1. The AC power switches light
up green when switched on and power is supplied.
The ED-48000B automatically performs a power on self-test
(POST) by default each time it is powered on. POST takes
approximately 10 minutes and is complete when indicator light
activity returns to the standard state. For information about LED
patterns, refer to
CAUTION
!
To prevent a potential IP address conflict, do not connect the
ED-48000B to the network until the IP addresses are
configured. Refer to
Parameters,"
to run for 10 minutes (minimum) to complete POST after
powering on before you power off.
5
6
7
8
Chapter 4, "Monitor System
Chapter 3, "Initial Configuration
for additional information. Allow the ED-48000B
AC Switch Cover
Power Cord Retainer
Retainer Attaching Screw
Clamping Screw
Components".