Using The Click 600 - Wavetronix SmartSensor Matrix User Manual

Note. For more
information on the
Click 65x products,
see Click 65x Series
User Guide.
Note. For more
information on the
Click 600, see Click
600 Quick Start Guide.
22
SmartSensor Matrix User Guide
•
1
If you haven't already, run the sensor cable back to the traffic cabinet.
2
Place the Click 65x in the cabinet on a shelf or use U-channel
mounting brackets to attach it to the cabinet wall.
3
Start connecting the sensor conductors to the terminal blocks on the
sensor plug on the back of the Click 65x. Terminate them by inserting
each conductor into the corresponding round hole on the plug (match
each conductor to the label of the same color on the plug). Insert a
small screwdriver into the square hole above it, and rock upwards to
secure the conductor in place. Repeat with each conductor.
4 Repeat step 3 to land each sensor conductor into the correct terminal
block on the sensor plug.
5 Power the unit by using the switch in the back; power each con-
nected sensor by toggling the appropriate switches on the front of
the Click 65x.
6 Connect communication cables (Ethernet, SDLC, and/or RJ-11
jumper cables to contact closure RS-485 outputs) into their respec-
tive ports on the front of the Click 65x.

Using the Click 600

Figure 18. Installation with Click 600
1 If you haven't already, run the sensor cable back to the traffic cabinet.
2 Place the Click 600 in the cabinet on a shelf or use U-channel
mounting brackets to attach it to the cabinet wall.
3 Start connecting the sensor conductors to the terminal blocks on the
sensor plug on the back of the Click 600. Terminate them by inserting
each conductor into the corresponding round hole on the plug (match
each conductor to the label of the same color on the plug). Insert a
small screwdriver into the square hole above it, and rock upwards to
secure the conductor in place. Repeat with each conductor.
4
Repeat step 3 to land each conductor into the correct terminal block
on the sensor plug.
5
Power the unit by using the switch in the back; power each con-
nected sensor by toggling the appropriate switches on the front of
the Click 600.
6 Connect jumper cables from the RJ-11 jacks on the front of the Click
600 to your contact closure devices.