Telpar Codes; Telpar Command Summary - Ithaca 150 Programmer's Manual

Control Codes

TELPAR Codes

Telpar Codes
This section list the Telpar codes that are supported by the PcOS Series 150 Printer. The Telpar
emulation is intended to make it as easy as possible to replace a Series 50 Printer with a Series 150.

Telpar Command Summary

The following is a list of the Telpar commands that are supported.
Command
[CR]
[LF]
[ESC] [LF] <n>
[FF]
[CAN]
[ESC] 0 <n>
[ESC] 3 <n>
ESC VT <n>
[ESC] @
[SO]
[SI]
[BEL]
[ESC] +
[ESC] !
[ESC] [BEL] <n>
[ESC] a <n>
[ESC] c <n>
[ESC] b <n>
[ESC] d <n>
[ESC] " <n>
[ESC] [DEL]
[ESC] [DC1]
[ESC] [DC3]
[ESC] [NAK]
[ESC] [SYN] <n>
[ESC] [DC2]
[VT]
[SOH] <n>
[SOH] A
[SOH] B
[SOH] C
[SOH] [DC3]
Page 80
PcOS Series 150
Description
Print and carriage return.
Print and line feed.
Feed <n> number of lines.
Advance to top of form.
Clear buffer; restore defaults.
Set page length in lines.
Set extra dot row feeds per line.
Feed <n> number of dot rows.
Reset printer.
Set double-wide print.
Cancel double-wide print.
Open Cash Drawer 1.
Open Cash Drawer 1.
Open Cash Drawer 1.
Open Cash Drawer 1.
Open Cash Drawer 1.
Open Cash Drawer 1.
Open Cash Drawer 2.
Open Cash Drawer 2.
Open Cash Drawer 2.
Deactivate all option drivers.
Open for validation.
Close for validation.
Close for validation with autoform sense.
Close for validation with autoform sense.
Cycle autocutter.
Feed to cut position.
Select multidrop printer.
Select printer with address, A.
Select printer with address, B.
Select printer with address, C.
Select all printers.
Rev G
Programmer's Guide
12/14/99