Options; Save Changes - Ithaca 150 Programmer's Manual

Configuration Mode
The serial port DTR and/or RTS signal can be configured to provide flow control. If DTR is
configured as the flow control signal, it will toggle to false when the buffer is full, RTS will not.

Options

The knife is an optional feature on the Series 150 Printer. If the hardware is installed, the
corresponding feature should be activated.

Save Changes

In self-configuration, the save changes must be set to "Yes" for any configuration changes to be
accepted. The next group selection will then save the changes and start normal operation.
Page 106
PcOS Series 150
Rev G
Programmer's Guide
12/14/99