Ithaca 150 Programmer's Manual page 83

Programmer's Guide
Function
ASCII
Description
Function
ASCII
Description
Function
ASCII
Description
Function
ASCII
Description
Function
ASCII
Description
12/14/99
PcOS Series 150
Enable/disable panel buttons
[ESC] c 5 <n>
The Series 150 Printer does not allow the front panel to be disabled.
Enable/disable on-line switch
[ESC] c 6 <n>
The Series 150 Printer ignores this command.
Generate pulse
[ESC] p <m> <t1> <t2>
The Series 150 Printer does not allow the cash drawer pulse to be
altered under software control. The <t1> <t2> parameters are ignored.
<m> selects Drawer 1 or 2.
Set impact energy
[GS] E <n>
The Series 150 Printer allows higher impact energy in validation
modes only.
Set bar code height
[GS] h <n>
This command sets the bar code height in dot lines. The Series 150
Printer prints bar codes in eight dot passes in graphics. The height
used in EPOS is intended for thermal printers. To allow some type of
compatibility between EPOS and the Series 150 Printer, the value of
<n> is divided by 28. This allows a similar size bar code to be printed.
Note: Values less than 28 return the printer to the default values
defined by the [ESC] [EM] B command in normal mode.
Rev G
Control Codes
EPOS Deviations
Page 73