Ithaca 150 Programmer's Manual page 82

Control Codes
EPOS Deviations
Function
ASCII
Description
Function
ASCII
Description
Where m
Function
ASCII
Description
Function
ASCII
Description
Function
ASCII
Description
Function
ASCII
Description
Page 72
PcOS Series 150
Set print direction
[ESC] T <n>
The Series 150 Printer does not implement page mode. This command
uses the normal rotated print format procedures. See [ESC] r <n> in
normal mode.
Note: EPOS reverses Modes 1 and 3.
Print graphics
1 2
[ESC] * <m> <n> <n>
The Series 150 Printer defines the extended graphic modes. Mode 4 is
normally 80 dpi. The Series 150 Printer does not support 80 dpi. If
Mode 4 is selected, 72 dpi will be used.
Print n1 + 256 * n2 bytes of graphics where m specifies the density.
0 Single-density graphics
1 Double-density graphics
2 Double-density half-speed graphics
3 High-density graphics
4, 5 CRT II screen
6 CRT I screen
7 Dual plotter
Turn 90 clockwise font ON/OFF
[ESC] V <n>
The Series 150 Printer uses the rotated 90 font to implement this
command. If one dot spacing is selected, ten cpi is used. If 1.5 dot
spacing is selected, eight cpi is used.
Select print paper
[ESC] c 0 <n>
The Series 150 Printer uses this command to select a print station. The
Series 150 Printer does not keep track of different settings for each
mode. If a specific print mode is required, it must be respecified.
Select print paper for setting
[ESC] c 1 <n>
The Series 150 Printer does not keep track of different settings for
each mode. If a specific print mode is required, it must be respecified.
Select detectors to stop printing
[ESC] c 4 <n>
The Series 150 Printer does not stop at the end of forms. The
application must keep track of the form length.
Rev G
Programmer's Guide
60 dpi
120 dpi
120 dpi
240 dpi
72 dpi
90 dpi
144 dpi
12/14/99