Ithaca 150 Programmer's Manual page 54

Control Codes
Rotated Print
Function
ASCII
Hexadecimal
Decimal
IPCL
EPOS
Description
Page 44
PcOS Series 150
Set rotated print line spacing
[ESC] u <n > <m > <n > <m
1 1 2
1BH 75H <n > <m > <n > <m
1 1 2
<27> <117> <n > <m > <n
1 1
none
none
This command adjusts the line spacing for each rotated print line where n
the line number and m
i
previous line.
L e ft m a r g in
n = 1 , m
n = 2 , m
For the first print line, the distance is calculated from the margin. An n
of 0 is used to terminate the command. Any unspecified spacing will be set to
one. This allows data to be accurately positioned on an inserted form. These
values will be used as a template for all subsequent rotated print. On power up,
all spacing is preset to 1/80 inch (n = 1, 8 lines per inch) for all lines. This
command is only effective in 90° and 270° rotation. It will remain in effect
until a new table is received or until the printer is power cycled. An [ESC] u
<0> will have the effect of setting all lines to one. This table can be overridden
by [LF] or [ESC] J <n> commands in the rotated print data.
The value of m can be from one to 127; n can be from one to 22.
Table 12 on 40 specifies the line spacing for this command.
Rev G
Programmer's Guide
> ... <n > <m > <0>
2 i i
> ... <n > <m > 00H
2 i i
> <m > ... <n > <m > <0>
2 2 i i
is the spacing in dot columns (1/80 inch) from the
E d g e o f fo r m
F irst lin e
S e c o n d lin e
T h ird lin e
is
i
value
i
12/14/99