Ithaca 150 Programmer's Manual page 31

Programmer's Guide
Function
ASCII
Hexadecimal
Decimal
IPCL
EPOS
Description
Function
ASCII
Hexadecimal
Decimal
IPCL
EPOS
Description
Function
ASCII
Hexadecimal
Decimal
IPCL
EPOS
Description
Function
ASCII
Hexadecimal
Decimal
IPCL
EPOS
Description
Function
ASCII
Hexadecimal
Decimal
IPCL
EPOS
Description
12/14/99
PcOS Series 150
Set form length in lines
[ESC] C <n>
1BH 43H <n>
<27> <67> <n>
&%SL <m > <m >
1 2
[ESC] C <n>
This command sets the form length to <n> lines at the current line spacing.
Set form length in inches
[ESC] C [NUL] <n>
1BH 43H <0> <n>
<27> <67> <0> <n>
&%SI <m > <m >
1 2
none
This command sets the form length to <n> inches.
Begin auto line feed
[ESC] 5 <01>
1BH 35H 01H
<27> <53> <01>
&%MA
none
This command sets auto line feed mode.
Note: This overrides the configuration setting.
End auto line feed
[ESC] 5 <0>
1BH 35H 00H
<27> <53> <0>
&%CA
none
This command ends auto line feed mode.
Note: This overrides the configuration setting.
Reverse line feed
[ESC] ]
1BH 5DH
<27> <93>
&%LR
none
This command performs a reverse line feed at the current line spacing.
Note: The receipt station can tolerate no more than 1/2 inch of reverse feed.
Note: This command is not available in models with validation.
Rev G
Control Codes
Vertical Motion
Page 21