Control Codes
STAR Codes
Control codes used for graphic printing
[ESC] 1
[ESC] A
[ESC] 2
[ESC] J <n>
[ESC] z 0
[ESC] K <n1> <0>
[ESC] L <n1> <n2>
[ESC] h 1
[ESC] h 0
Control codes used for peripheral units
[BEL]
[EM]
[FS]
[SUB]
Other control codes
[RS]
[CAN]
[ESC] U 1
[ESC] U 0
[ESC] @
[ESC] ! *
[ENQ]
[ESC] d 0
[ESC] d 1
[ESC] W 1
[ESC] W 0
[ESC] y <n>
[ESC] 3 <n>
11
This command only functions if the internal buzzer option was installed at the factory.
12
The printer can be equipped with either a full or partial cutter option.
Page 78
PcOS Series 150
Set 7/72-inch line feed.
Define n/72-inch line feed.
Set n/72-inch line feed.
Set one-time line feed of n/72-inch.
Set 1/12-inch line feed.
Set 8-dot single-density bit image.
Set 8-dot double-density bit image.
Select vertical expanded character mode.
Cancel vertical expanded character mode.
Defer drive command for Peripheral Unit 1.
Set immediate drive command for Peripheral Unit 2.
Set immediate drive command for Peripheral Unit 1.
Set immediate drive command for Peripheral Unit 2.
Activate sound buzzer. 11
Cancel print data in buffer.
Select unidirectional print mode.
Select bidirectional print mode.
Initialize printer.
End italics.
Perform inquiry.
Cycle autocutter. 12
Cycle autocutter.
Select expanded character mode.
Cancel expanded character mode.
Set n/144-inch line feed.
Set n/216-inch line feed.
Rev G
Programmer's Guide
12/14/99