Validation - Top Insertion; Validation - Left-Side Insertion; Figure 5 Validation Print - Top Insertion; Figure 6 Validation Print - Left-Side Insertion - Ithaca 150 Programmer's Manual

Programmer's Guide

Validation - Top Insertion

4.25 inches (min)
(107.95 mm)
Figure 5 Validation print – top insertion

Validation - Left-side Insertion

Last line of print
6.00 inches (min) (152.40 mm)
Figure 6 Validation print – left-side insertion
Validation Forms Insertion
Form insertion is from the top or the left side of the printer. Automatic form location is
under software or firmware control. Character rotation under software control will allow
check validation to appear right-side up when the check is removed.
12/14/99
PcOS Series 150
2.34 inches
(59.44 mm)
0.50 in
(12.70 mm)
2.50 inches (min) (63.50 mm)
First line of print
0.50 inch
(12.7 mm)
2.85 inches
(72.39 mm)
2.34 inches
0.68 inch (17.15 mm)
(59.44 mm)
Rev G
General Specifications
First line of print
2.85 inches (72.39 mm)
Last line of print
0.68 inch (17.15 mm)
2.50 inches (min) (63.50 mm)
Page 11