Ithaca 150 Programmer's Manual page 80

Control Codes
EPOS Codes
[ESC] <
[ESC] =
[ESC] ?
[ESC] @
[ESC] B <n>1 <n>2 <n>3
... <n>i 0
[ESC] C <n>
[ESC] D <n>1 <n>2
<n>3 ... <n>i 0
[ESC] E <n>
[ESC] G <n>
[ESC] J <n>
[ESC] K <n>
[ESC] M <n>
[ESC] Q <n>
[ESC] R <n>
[ESC] U <n>
[ESC] V <n>
[ESC] [ <m> <n>
[ESC] \ <n > <n
L
[ESC] ^ ...
[ESC] a <n>
[ESC] b <n>
[ESC] c <n>
[ESC] d <n>
[ESC] e <n>
[ESC] f <t1> <t2>
[ESC] I
[ESC] l <n>
[ESC] m
[ESC] p <m> <t1> <t2>
[ESC] q
[ESC] t <n>
[ESC] u <n>
[ESC] v
[ESC] x <n>
[ESC] { <n>
[ESC] ~ <n>
[GS] !
[GS] I <n>
[GS] L ...
[GS] W ...
[GS] h <n>
[GS] k <m> ... <0>
Page 70
PcOS Series 150
Not the same
Ignored
Extension
Similar
Extension
Not implemented
Similar
>
H
Similar
Not implemented
Similar
Similar
Extension
Extension
Extension
Extension
Extension
Rev G
Programmer's Guide
Return home (not necessary with the Series
150 printer).
Select peripheral device (Pass through).
Cancel user-defined characters.
Initialize printer.
Set vertical tab stops.
Set form length.
Set horizontal tab stops.
Turn emphasize mode ON/OFF.
Turn double-strike mode ON/OFF.
Print and feed.
Print and reverse feed.
Select character font.
Set right margin in characters.
Select International Character Set.
Turn unidirectional mode ON/OFF.
Turn 90 clockwise mode ON/OFF.
Select code page/print features (same as
normal mode).
Set relative print position.
Set Epson 9-pin bit image.
Set left, center, or right justify.
Print bar code (same as normal mode).
Select station. See description below.
Feed <n> lines.
Print and reverse feed.
Set wait time. See description below.
Set full cut.
Set left margin in characters.
Set partial cut.
Generate pulse. See description below.
Release form.
Select Character Code Table (may vary from
Epson Select Code).
Return status of cash drawer (Serial and IEEE
1284 only).
Return null byte to host.
Set print font (same as Normal [ESC] I <n>).
Turn upside down print ON/OFF.
Test mode diagnostic commands.
Select character size.
Transmit specified ID (different than Epson).
Set left margin in 1/160 inch.
Select printable area in 1/160 inch.
Set bar code height.
Print bar code.
12/14/99