General Specifications
Receipt/Journal Paper
Paper-feed method
Paper-feed pitch
Paper width
Roll diameter
Paper thickness at 25 C
Two-ply
Three-ply
Roll paper core
Roll footage (typical)
Two-ply
Three-ply
Receipt-paper out
Printable Area
Receipt Printing
Paper tear-off
2.34 inches
(59.44 mm)
3.25 inches
(82.55 mm)
Figure 4 Receipt printable area
Receipt Printing with the Autocutter
The paper is cut one inch from the last line of print, which minimizes the wasted paper
required when the paper must be moved to the cut-off position.
Validation Forms Printing
Lines per inch (lpi)
Table 4 Validation lines
Page 10
PcOS Series 150
Friction feed
Default - 0.13 inch (1/8 inch or 3.18 mm); can be set in units of
0.0046 inch (1/216 inch or 0.12 mm) by software command
2.75, 3.00, or 3.25 inches (69.85, 76.20, 82.55 mm)
3.50 inches (88.90 mm)
0.006 - 0.007 inch (0.15 - 0.18 mm)
0.009 - 0.0105 inch (0.23 - 0.27 mm)
Inside diameter 0.44 inch (7/16 inch or 11.11 mm)
110 feet (3353 cm)
70 feet (2134 cm)
Paper exhaust is sensed by software, and printing is prevented at the
end of the roll.
1.00 inch (25.4 mm)
0.46 inch (11.68 mm)
8
6
Rev G
Programmer's Guide
Lines
16
12
12/14/99