Validation Operation - Ithaca 150 Programmer's Manual

Control Codes

Validation Operation

Validation Operation
The form is inserted from the top and extends out the left side and/or top of the printer. It rests on
a fixed stop. A maximum of 16 lines at 40 characters can be printed on a form. In this manual,
top insertion will be termed validation mode.
Function
ASCII
Hexadecimal
Decimal
IPCL
EPOS
Description
Function
ASCII
Hexadecimal
Decimal
IPCL
EPOS
Description
Function
ASCII
Hexadecimal
Decimal
IPCL
EPOS
Description
Page 52
PcOS Series 150
Open for validation
[ESC] [DC1]
1BH 11H
<27> <17>
&%VO
[ESC] c 0 <n>
This command opens the form compensation assembly for validation. No
automatic validation form sensing is performed. The application must poll
the printer for validation forms present and then issue a close
compensation command.
Close for validation
[ESC] [DC3]
1BH 13H
<27> <19>
&%VC
[ESC] c 0 <n>
This command closes the form compensation assembly for validation. No
automatic validation form sensing is performed.
Close for validation when form is sensed
[ESC] [DC4]
1BH 14H
<27> <20>
&%VS
[ESC] c 0 <n>
This command closes the form compensation assembly for automatic
validation form sensing by the printer.
Rev G
Programmer's Guide
12/14/99