Ithaca 150 Programmer's Manual page 107

Programmer's Guide
General
10 cpi The 10 cpi command can be prevented from being acted on.
If set to disable, the printer will ignore the 10 cpi command
(DC2).
Active
Disabled
Print Illegal
Commands
No
Yes
Print Zone There are two print zone settings.
Normal (2.40 inch)
Wide (2.83 inch)
Series 50 The Ithaca Series 50 Printer uses several commands that are
Compatibility not supported by the Series 150 Printer. In some cases, these
commands have different functions in the Series 150 Printer.
If this option is set, the Series 50 commands are activated
and overlapping Series 150 commands deactivated.
Off
On
Vertical
Control
Line Spacing The line spacing can be defaulted to 6 or 8 lpi.
6 lpi
8 lpi
Auto Line An auto line feed feature can be set as a default where all
Feed [CR]'s will have a [LF] added. If auto line feed is set to on,
this feature is activated.
Off
On
Auto Carriage An auto carriage return feature can be set as a default where
Return all [LF]'s will have a [CR] added. If auto carriage return is set
to on, this feature is activated.
Off
On
Form Length The default form length can be set from 3 to 17 inches. This
configuration affects how the [FF] command operates.
3 to 17 inches
Line Feeds The number of line feeds before a cut operation is performed
Before Cut can be set from 0 to 15 lines.
0 to 15 lines
Character
Print Mode The default print mode can be set to Draft, Utility, NLQ
Courier, or NLQ Sans Serif. In most cases, Draft or Utility
mode will be the default selections.
Draft
Utility
NLQ Courier
NLQ Sans Serif
Character The default print pitch can be set to 8, 10, 12, 15, 17.1, 20, or
Pitch 24 characters per inch.
8 cpi
10 cpi
12 cpi
15 cpi
17.1 cpi
20 cpi
24 cpi
12/14/99
PcOS Series 150
Rev G
Configuration Mode
Recommendation
11
0
Page 97