Securing In Place (Leg Adjuster Adjustment) - Sega AFTER BURNER CLIMAX Owner's Manual

3.5.2 SECURING IN PLACE (LEG ADJUSTER ADJUSTMENT)

• Make sure all of the leg adjusters are in contact with the floor. If they are not, the
machine may move and cause injury. This operation requires 2 people.
• This operation should only be carried out by QUALIFIED SERVICE
PERSONNEL.
This machine has four castors and four leg adjusters. When the installation position is decided, unscrew
the leg adjusters so that they raise each caster a minimum of 5mm from the floor. Make sure the machine
is level.
1. Move the machine to the installation position. When installing
against or close to a wall, be sure to allow an adequate space to
allow the player access to the machine.
2. Make the leg adjusters contact the floor. Adjust using a spanner as
shown below so that a minimum of 5mm exists between the
casters and the floor. Make additional adjustment so that the
machine is level.
3. After making adjustments, fasten the lock nut upward on all four
adjusters.
4. Install the SUPPORT BRACKETS on the left and right side of the frame. Remove the two M8 bolts
shown below and replace them to secure the SUPPORT BRACKETS.
Repeat procedure for both Left and Right sided
support plates.
12