Replacement Of Fluorescent Lamps - Sega AFTER BURNER CLIMAX Owner's Manual

4.3 REPLACEMENT OF FLUORESCENT LAMPS

•
•
•
•
•
•
This product has 1 fluorescent lamp in the billboard
1) Cut off the power supply.
2) Remove 4 truss screws from atop the billboard.
3) Remove the billboard lid and replace the fluorescent lamp.
When working with the product, be sure to turn the power off. Working with the power
on may cause an electric shock or short circuit.
You may get burned by a hot fluorescent lamp or other lamps. Pay full attention to the
lamps when performing the work.
There is the danger of short circuits or smoke generation due to deterioration of
insulation in lighting fixtures resulting from age deterioration. Check for anomalies
such as the following: Does it smell like something is burning? Is there socket
discoloration? Are any lamps being replaced frequently? Do lamps not go on
properly?
Before turning on the power after a fluorescent lamp has been replaced, inspect
carefully to see if anyone is near the product or if tools or other items have been left
on the product. When the power is turned on, initialization takes place automatically.
If anyone is near the product, they could collide with the product or come in contact
with it accidentally. Accidents could also occur if tools or other items fly off the
product.
Be careful when handling the plastic parts. Failure to observe this may cause injury or
damage due to fragments, etc.
Do not attempt to replace billboard fluorescent lamps while standing on the base. If
you should misstep while working, you could stumble or fall down.
39