Connecting The Power - Sega AFTER BURNER CLIMAX Owner's Manual

3.5.4 CONNECTING THE POWER

• Be sure that the machine is not already connected to the mains supply before
attempting this operation
• This operation should only be carried out by QUALIFIED SERVICE
PERSONNEL.
1. Insert the mains lead into the wall socket.
2. Insert the IEC plug into the IEC socket on the
AC bracket.
3. Switch on the power supply at the wall.
4. Switch on the mains switch on the AC bracket.
5. Once power is turned on, the fluorescent
lamps in the top and rear billboards light
up. The Start System Screen displays
after a lapse of several seconds. It is
followed by the screen that indicates that
the network is currently being checked if
the communication mode has been set. If
there is a bad
communication connection, each screen
will not proceed to the next, remaining on
the currently network-checked screen. If
this occurs, resolve the error according to
the instructions in this manual.
6. If the communication mode has not been
set or the communication check ends
normally failures are displayed, if found.
Resolve the errors according to the
instructions in this document. Pressing
the Start button while a failure is on-
screen allows you to go to the next
screen and start the game without
reaction.
7. Once all the above steps have been completed, the Advertise Screen displays and voices are output
through the left and right loudspeakers, unless you have set the machine so that no voices are output
during the Advertise mode.
This product retains the number of credits and the ranking data even after the power is turned off. It does
not retain data about the fractional number of coins (i.e. the number of coins not reaching one credit) or the
bonus adder count.
or improper
16