4.2.1 GREASING
•
•
•
Once every 3 months apply grease to the spring and gear mesh that turn the volume shaft.
1) Cut off the power from the supply.
2) Remove the 4 truss screws that hold the throttle cover lower. Flat washers are used with the truss
screws.
3) Remove throttle cover lower.
4) Apply grease only at designated locations.
5) When attaching throttle cover lower, make sure that wires do not get caught anywhere.
Be sure to use the designated grease. Using undesignated grease can cause parts
damage.
Do not apply grease to locations other than as specified. Doing so may create a
risk of operational problems and deterioration of parts.
The designated periods for greasing serve only as a guide. Whenever there are
squeaks or other anomalies, apply grease at designated locations.
34