13) Attach control stick
14) Engage the power. Note that initialization takes place.
15) Establish volume setting on the game test mode calibration screen
16) Simply changing settings on the calibration screen will not be effective. Terminate the test mode.
Note that initialization takes place upon termination of the test mode.
4.1.4 MICROSWITCH REPLACEMENT
If operability of the gun trigger is unsatisfactory, the problem could be a malfunction of the microswitch
inside the control stick grip.
Remove the control stick and replace the microswitch.
Use the following tools, solder and screw lock agent (PART NO. 090-0012).
- 2.5 mm Allen wrench or screwdriver
- 8 mm spanner, Allen screwdriver or socket wrench
- Philips screwdriver (for M4 screw)
- Soldering iron
1) Cut off the power and remove the control stick
2) Press down on the rubber cover at the base of the control stick grip.
3) Take out 3 screws and remove grip R. Be careful when removing the grip that parts inside the grip
do not come out and get lost.
30