Figure 7-11. ACEs Associated with IP-ACL
Removing an IP based ACL
1 Open the Network Security - IP Based ACL page.
2 Click Show All. The ACEs Associated with IP-ACL Table opens.
3 Check the Remove ACL checkbox.
4 Click Apply Changes.
Removing an IP based ACE
1 Open the Network Security - IP Based ACL page.
2 Click Show All. The ACEs Associated with IP-ACL Table opens.
3 Check the Remove checkbox next to an ACE.
4 Click Apply Changes.
Configuring IP Based ACLs with CLI Commands
The following table summarizes the equivalent CLI commands for configuring I P Based ACLs .
Table 7-5. IP Based ACL CLI Commands
CLI Command
ip access-list access-list-name
no ip access-list access-list-name
232
Configuring Device Information
Description
To define an IPv4 access list and to
place the device in IPv4 access list
configuration mode, use the ipv4 access-
list command in global configuration
mode. To remove the access list, use the
no form of this command.