Dell PowerConnect 54 Series User Manual page 268

Configuring Static Address Parameters Using CLI Commands
The following table summarizes the equivalent CLI commands for configuring static address parameters as
displayed in the Static MAC Address page.
Table 7-16. Static Address CLI Commands
CLI Command
bridge address mac-address {ethernet
interface | port-channel port-channel-
number} [permanent | delete-on-reset |
delete-on-timeout | secure]]
show bridge address-table [vlan vlan]
[ethernet interface | port-channel port-
channel-number]
The following is an example of the CLI commands:.
Console# show bridge address-table
Aging time is 300 sec
vlan
----
1
1
200
g8
268
Configuring Device Information
Description
Adds a static MAC-layer station source
address to the bridge table.
Displays entries in the bridge-forwarding
database.
mac address
------------
00:60:70:4C:73:FF
00:60:70:8C:73:FF
00:10:0D:48:37:FF
00:10:0D:98:37:88
port type
---- --------
g8 dynamic
g8 dynamic
g9 static
dynamic
g8