Table of Contents
Advertisement
Displaying Optical Transceiver Diagnostics Test Results Table
1 Open the Optical Transceiver Diagnostics page.
2 Click Show All.
The test is run and the Virtual Cable Test Results Table opens.
The Optical Transceiver Diagnostics Table contains the following columns:
•
Temp — Internally measured transceiver temperature.
•
Voltage — Internally measured supply voltage.
•
Current — Measured TX bias current.
•
Output Power — Measured TX output power in milliwatts.
•
Input Power — Measured RX received power in milliwatts.
•
TX Fault — Transmitter fault.
Finisair transceivers do not support the transmitter fault diagnostic testing.
•
LOS — Loss of signal.
•
Data Ready — The transceiver has archived power up and data is ready.
•
N/A — Not Available, N/S - Not Supported, W - Warning, E - Error.
Fiber Optic analysis feature works only on SFPs that support the digital diagnostic standard SFF-4872.
Performing Fiber Optic Cable Tests Using CLI Commands
The following table summarizes the equivalent CLI command for performing fiber optic cable tests.
Table 6-24. Fiber Optic Cable Test CLI Commands
CLI Command
show fiber-ports optical-transceiver
[
]
[interface]
detailed
Description
Displays the optical transceiver
diagnostics.
Configuring System Information
125
Advertisement
Table of Contents
