Dell PowerConnect 54 Series User Manual page 86

• Remove — Removes a specific SNTP server from the SNTP Server list, when selected.
Adding an SNTP Server
1 Open the SNTP Servers page.
2 Click Add.
The Add SNTP Server page opens:
Figure 6-12. Add SNTP Server
3 Define the fields.
4 Click Apply Changes.
The SNTP Server is added, and the device is updated.
The following table summarizes the equivalent CLI commands for setting fields displayed in the Add SNTP
Server page.
Table 6-8. SNTP Server CLI Commands
CLI Command
sntp server ip-address|hostname [poll]
[key keyid]
The following is an example of the CLI commands:
console> enable
console# configure
Console(config)# sntp server 100.1.1.1 poll key 10
Displaying the SNTP Server Table
1 Open the SNTP Servers page.
2 Click Show All.
The SNTP Servers Table opens:
86
Configuring System Information
Description
Configures the device to use SNTP to request and accept NTP traffic
from a server.