Table of Contents
Advertisement
E-025-2-E
3.11 Troubleshooting
3.11.1 If There is No Response
If there is a problem preventing communication between the PC and flowmeter when the flowmeter is
connected as described in section "3.2 Starting LinkTop and Connections", or while this application
is being used, then a message box will appear as shown in Fig. 142. Click "OK" if this happens,
then verify the following and try reconnecting as described in section "3.2 Starting LinkTop and
Connections":
- Is the communication interface's probe or PC disconnected?
- Is the flowmeter transmitter receiving power?
3.11.2 If It is Not Possible to Connect to the Flowmeter
When connecting the flowmeter to the transmitter in "3.2 Starting LinkTop and Connections", a
message box in Fig. 143 will be displayed if the flowmeter transmitter is not supported by this
application software. In this case, click "OK" and make sure the connected flowmeter transmitter
meets this application.
3.11.3 Input Errors
If invalid values are inputted during "3.6 Menu: Setup (Settings)" or "3.7 Menu: Diag/Service (Checking
and Adjustment)", an error will be displayed.
① If the entered data cannot be identified as a numeric value or the required items are left blank, an
error message box similar to Fig. 144 will be displayed. Click "OK" and correct the relevant data.
2
Fig.142
Fig.143
Fig.144
Advertisement
Table of Contents
